Dejan Nokia BB5 Box with 3300 credits@110 phones

Nokia BB5 phones unlocking box from Dejan. Doesn't require Internet connection to work - it has integrated phones counter! Doesn't require any other boxes to work. No credits lost. All you need is PC and some skills in disassembling phones and using testpoints.

Supported phones list:

Important information
1. Copy and paste bb5_unlocker folder to C:/ drive
2. Open bb5_unlocker folder and run install.bat
3. After install finished, message will appear "bb5 box not found", press ok
4. Connect box to usb port on computer
5. Windows will ask for driver, browse to folder "bb5_unlocker" -> "winxp dejan", and let windows install drivers
6. Go to Device Manager
7. Go to Ports (COM & LPT)
8. right-click on dejan bb5 box and go to properties
9. change com port to lowest possible (port 2)
10. click on scan for hardware changes
11. click ok
12. open bb5unlocker sw
13. connect cable to box
14. open phone
15. connect positive (red connector) to 1st pin (left) of batt connector
16. connect bsi (yellow connector) to 2nd pin (middle) of batt connector --> NOT need for 6280
17. connect GND (black crocodile clip) to vibrator. for 6131 need to connect to pop port connector of phone
18. connect cable to phone connector
19. power up phone
20. click on read info on sw
21. phone info will appear with lock status
22. if try 1 = 2,3,4,10 or any number, this has no affect (this is wrong unlock by code)
23. if try 2 = 10, then phone CANNOT be unlocked (this is wrong unlock by fbus). if counter is 0, then after unlocking
or wrong unlock a backup is autmatically stored in backup folder in bb5_unlocker folder. everytime after a wrong
unlock (usually by touching other pins on rap ic, and therefore causing the phone to switch off, then sw cant read
and error will appear on screen) then counter will increase, if goes up to 4 or 6 then you must press
"write backup" to reset counter.
24. CLK = CLOCK = small tp
25. AD1 = DATA = big tp with unlock ignition switch
26. connect tp's on top of pins shown on tp photo, lightly pushing down the spring loaded pins of tp connectors down on
tp pins, only slightly, just touching, otherwise rap3g ic will damage
27. just click ignition button on DATA tp, keeping tp connectors connected to pins
28. phone will unlock within 3-5 secs and will show unlock successful message
29. if message appears: cannot unlock phone! - this means tp pins you connected are incorrect or lost connection,
then take out rj45 cable out from box and put back, then switch on phone again and repeat procedure.